garageCube

Hey Guys!
I bought two very cheap varytec led rotobars. i tested different madmapper dmx-fixtures. Now i think, i need the possibility to control the first three channels (1. Tilt 2. Strobe 3. Dimm) separate in modul8 via simple fader. The other channels i control in madmapper (5.- ... Color).

Could some body tell me, if it´s possible to use ONE Enttec USB/ Artnet Donggle on ONE Mac in TWO programs? I want to control DIFFRENT DMX Channels through modul8 + madmapper.

maybe somebody has a solution for me! Thanks!

Both modul8 and madmapper send all the values of one universe so if you use both at the same time, they will step on each other with zeros…

You could use an enttec ode with a plugin that gets only the highest values. Not sure it will work though.

Thanks! I´ll try it!