I am trying to launch interactive setup which includes :
1. Pi Cap from Bare Conductive +raspberry Pi - sending OSC signal (thru their script) https://github.com/BareConductive/picap ... eam-osc-py to Processing software on PC
2. Processing software on PC running script https://github.com/BareConductive/picap-madmapper and communicating with Madmapper
3. Madmapper on PC receiving OSC signal from Processing
My question is if I can avoid installing PC and substitute it with Minimad? This will also require moving 'Processing' software to raspberry pi ,or maybe to Minimad ? since it is raspberry platform .There is Linux version of Processing available .The new setup would look like this then:
1.Pi Cap from Bare Conductive +raspberry Pi + possibly 'Processing' software receiving OSC signal from Pi Cap and forwarding commands to Minimad thru same script as mentioned above ?
2. Minimad receiving OSC signal from Processing (or maybe there is some way to install Processing on Minimad ??)
I know I have to change commands in Madmapper script as they differ from Minimad's - Matt advised that -I have similar post about that on Madmapper's section.
Whole idea is to have only two boxes -Raspberry & Minimad. Would that theoretically work ? Don't have Minimad yet ,as want to figure out if for this kind of permanent installation & setup if all this would work.