garageCube

have a minimad 16 gigs
download the 16 gigs image and flash the sdcard no problem
went thru the set up process fine ( red, y,green buttons )
remove card from mini and export an exsiting project that worked fine with previous
image
boot the minidad / minimad keeps rebooting over and over

Image 3.1 worked with the same project file


any solutions?
are other user having same issue?

We've noticed a problem with MadMapper 3.2 build and we'll release MadMapper 3.2.1 asap today.

MadMapper 3.2.1 with fixes for the miniMAD is now available for download on Yourspace:
http://madmapper.com/yourspace/

MadMapper 3.2.2 comes another miniMAD update fix.
It should work for everybody now.

Hy,

I just updated to Madmapper 3.2.2

While exporting to minimad, the update of the card went fine, but is still crashing when i put it the minimad
This is the line where it always blocks ...same in another minimad
[ 4.358179] ——-[ end Kernel panic - not syncing : UFS : Unable to mount root fs on unknown-block(179,2)

NB : i have another card, it works fine

The kernel panic message means the system got somehow corrupted.

You can either duplicate your working SD-card or flash it using the official SD-card image.
You'll find the necessary files and instructions on Yourspace.

Hi,

Thanx, i tried with Etcher 1.2.1 and with the latest 16GB Disk-image, both downloaded from yourspace.

With a 16GB card, Etcher says that the card is too small for the image !?

My bad, the SD-cards shipped with the latest miniMAD are slightly smaller than the previous, hence an adaptation of the image has been necessary, but I forgot to change the link to the 16GB image on Yourspace...

Sorry for that.

I just fixed it, so please download the image again and you should be able to flash the new image to your card.

yep, ok now, works fine
thx