garageCube

Hi there,

we would like to know if it's possible to use a (not modul8) midi controller connected by usb port to mad mapper. We need it for a interactive installation, the controller we would use is the Bare conductive touch board (https://www.bareconductive.com/shop/touch-board/)

Unlike the miniMAD (which only supports micromodul8) you can basically use any MIDI controller with MadMapper,
there's a versatile and very helpful assign MIDI controls function within the software.
Still, your touch board will require a bit of -diy- setup and perhaps coding (I mean if you use Arduino products), following this info from your link :
You’ve got a Hackable MIDI Controller
The Touch Board is the most flexible MIDI controller on the market. Turn any thing, any surface or any space into a USB MIDI controller. (which is good news btw)