Universe Syncronization
  • stevefromNewcastle
    junior Member
    Posts: 1
    Joined: Wed Sep 30, 2020 2:18 pm

    Universe Syncronization

    by stevefromNewcastle » Wed Sep 30, 2020 2:35 pm

    Hi all
    I have a setup of LED tape that is controlled from a MiniMad V4 running 10 universes of Artnet unicast to 2 controllers. I have the MiniMad running into a network switch with each controller. I seem to get dropped frames and or non synchronisation of the 2 units. To test I fade the LED up to a solid colour, some times both controllers work and some times only 1 does, sometimes they both work but there timings do not match. I have tested with LumiNet and I am only getting 8-9fps.

    When setup on Madmapper4 on an intel Nuc everything works as expected.
    Any help would be greatly appreciated.
  • Pierre Guilluy
    garageCube team
    Posts: 348
    Joined: Mon Oct 12, 2015 1:50 pm

    Re: Universe Syncronization

    by Pierre Guilluy » Fri Oct 02, 2020 1:42 pm

    You've contacted us through the support system as well, where we're busy finding a solution.

Who is online

Users browsing this forum: No registered users and 3 guests