Minimad Surfaces

Anything about the miniMAD!

Moderator: Pierre Guilluy

Minimad Surfaces

Postby hugoazarate » Sun Jan 22, 2017 2:09 am

Hello guys,

So, I bought the Minimad a few days ago and I'm still getting used to it. Yesterday I created a project just as a test to see if the Minimad would actually "transfer" what I did exactly on MadMapper. I have a plastic structure that I mapped, since it is an irregular shape, I had to use a mask for it. When I did the exporting to the Minimad, I only had the quad surface and since it was the one I used for the media input I thought it was all good. After I finished loading everything and connecting the Minimad, I noticed that it only projected the actual quad and it didn't saved the mask I did for the structure.
Did I missed to click something on the Madmapper software? Or did I do something wrong for this approach?

Every input is much appreciated. Thanks guys!
hugoazarate
Junior Member
 
Posts: 4
Joined: Sat Oct 03, 2015 3:33 am

Re: Minimad Surfaces

Postby Pierre Guilluy » Mon Jan 23, 2017 12:10 pm

As mentioned on the miniMAD webpage http://www.madmapper.com/minimad:

miniMAD 2.5 supports quad* and triangle surfaces.

Other surfaces (Circle, Mask, fixtures, Lines, 3d Surfaces) are not supported yet.

*Quad masks and shaders are not yet supported


You may be able to emulate a mask by creating a quad surface with red, green, blue values set to 0 (black mask).
Pierre Guilluy
GarageCUBE team
 
Posts: 100
Joined: Mon Oct 12, 2015 1:50 pm


Return to miniMAD (General)

Who is online

Users browsing this forum: No registered users and 2 guests