garageCube

Hi,

I was able to successfully export my files to my Mini-SD card from MadMapper. But when I plug the power of my Minimad, there's just a red and green leds (which don't blink at all) in the device, and it doesn't react or send video out (my monitor doesn't detect any HDMI video signal) ... also if I press red and blue buttons, it doesn't turn the unit off.

I used this Minimad a lot three years ago, I just had it stored, and I wonder why now it doesn't work.

Any suggestions??

Thanks a lot in advance

There must be a problem with the SD-card, most probably a data-corruption, and you will have to flash it with the original MiniMad image.

To do so, please refer to the official MiniMad user-guide: https://madmapper.com/minimad/userguides

Also, it happens that some dust gets stuck in the SD-card slot, and solving the problem is just about removing the card and blowing in the slot (it happened to me yesterday using a MiniMad that was unused for quite some time).