I tested the 3.0 Beta 1 over the last couple of days on both Mac and Windows and I have to say that I am really impressed on how well the Windows Version is running.
Today I tried the DMX Output via ArtNet and noticed some strange behaviour when looking for my ArtNet Interfaces on Windows.
I tried a setup with an "Enttec Open DMX Ehternet" and a "DMX 4 ALL Artnet Multi PixxControl":
Fist I used the Multi PixxControl with the IP 18.104.22.168. It shows up, but has the IP adress mixxed up and goes offline after just a few seconds.
I then tried to set it up manually, but did not get any response from any of my DMX fixtures.
Next I tried the Enttec interface (IP 22.214.171.124) wich gave me the same results...
I did the same tests on my Macbook and everything worked fine there.
Can anyone reproduce this?
Thanks for bringing MadMapper to Windows!!