Page 1 of 1

3.0 BETA 1 ArtNet Interface Issues (Win 7)

Posted: Mon Jun 05, 2017 12:11 am
by DwK Tobi
Hi all!

I tested the 3.0 Beta 1 over the last couple of days on both Mac and Windows and I have to say that I am really impressed on how well the Windows Version is running.

Today I tried the DMX Output via ArtNet and noticed some strange behaviour when looking for my ArtNet Interfaces on Windows.
I tried a setup with an "Enttec Open DMX Ehternet" and a "DMX 4 ALL Artnet Multi PixxControl":

Fist I used the Multi PixxControl with the IP It shows up, but has the IP adress mixxed up and goes offline after just a few seconds.

madmapper bug.PNG
madmapper bug.PNG (39.26 KiB) Viewed 2699 times

I then tried to set it up manually, but did not get any response from any of my DMX fixtures.
Next I tried the Enttec interface (IP wich gave me the same results...

madmapper bug 3.PNG
madmapper bug 3.PNG (37.79 KiB) Viewed 2699 times

I did the same tests on my Macbook and everything worked fine there.

Bildschirmfoto 2017-06-04 um 23.30.25.png
Bildschirmfoto 2017-06-04 um 23.30.25.png (143.37 KiB) Viewed 2699 times

Can anyone reproduce this?
Thanks for bringing MadMapper to Windows!!

Cheers, Tobi

Re: 3.0 BETA 1 ArtNet Interface Issues (Win 7)

Posted: Mon Jun 05, 2017 8:54 pm
by mad-matt
Oh, great feedback ! There's a ntohs or htons missing somewhere (there IP address bytes are flipped).
Be sure it will be solved in the next beta. For now use broadcast ! (until you use less than 30 universes it work fluently)