garageCube

Hello, I need some help please!
I got 2 Starter Kits from garageCube, 8x1mtr SFX 01 RGB and 16x0,5mtr SFX 01 RGB, using a Eurolite Artnet-DMX Node 8 MK2 with 2 Universes and Windows 10 Mad Mapper, i can control the sticks and have the correct response of the dmx output, but the led sticks are flickering from the beginning low to the end of the row more in different colours and in booth lines i have the same "effect". It seems like there is a bad signal from the Artnet Node. I tried the starter kits first with a enttec usb-dmx mk2 interface, no problem, just one universe, thats why i use artnet now. Maybe any Ideas? Should i try another Hardware? Someone with the same Problem? THX Andy

https://www.prolighting.de/eurolite-art ... gKXGfD_BwE

hi Andy,
did you solve your issue?

Are you using just one PSU or two?

Hey !

Same problem here !
We have praticly the same set up (we just have 3 univers of 50cmRGB). The end of each univers flick a lot and it's look like there's a bit of latency ...
We try : with another interface rj45/dmx and each univers work well, with another computer, change the cables and change ip.
Do you know if it's a compatibility problem or if we do something wrong ?

Thx <3

Hi,

We are experiencing similar issue, the bars flash/flicker randomly, it’s very sporadic.
Running just 2 x 1m bars (1 rgb and 1 w) controlled via the 8 universe controller from the Garagecube kit with the small 150w psu. Madmapper running latest update, OSX also latest update.
Artnet is set to unicast.

Any pointers on how to solve this are very appreciated, thank you

Hi,

We are experiencing similar issue, the bars flash/flicker randomly, it’s very sporadic.
Running just 2 x 1m bars (1 rgb and 1 w) controlled via the 8 universe controller from the Garagecube kit with the small 150w psu. Madmapper running latest update, OSX also latest update.
Artnet is set to unicast.

Any pointers on how to solve this are very appreciated, thank you

please contact the support via support@garagecube.com thank you