garageCube

Hello,
for an autonomous installation, there are 2 artnet nodes (8 univers each) connected to a RJ45 hub.
The ip address for the first node is : 2.13.2.252, the second is : 2.13.2.253.
How should I configure the minmad network configuration please ?

thanks in advance

ok after some few tests, it isn't difficulte at all. From Madmapper, juste built your led sequences and upload it to the sd card, the ip adress must be set to the first artnet node
Et voilà

you can see our led installation running under 1 minimad and 2 nodes in the Geneva Lux Festival 2024 (under the Kiosk - Jardin Anglais)