garageCube

[Gstettner]

Hello, I have been using Madlaser for a long time, but since version 5.1.6 I always have an error with my Laserworld Shownet.
I can no longer connect in the program.
I have already tried it with Auto IP and a Static IP and it always fails to connect.

What could be the reason?

thanks for your help patrick.

[mad-matt]

First, you should use MadMapper 5.6.8. Minor updates are free and there are plenty of bug fixes since 5.1.

Things to check:
- If device is in auto-ip, your computer network adapter must be set to DHCP and have no other network interface in an Auto IP adress. If your device is in static IP, be sure your computer IP is different from any device IP on the network & with the good network mask, for instance if device is 192.168.1.11, set computer to 192.168.1.2 & ip mask 255.255.255.0
- Disable Firewall to see if firewall can be blocking MadMapper
- Disable other network interfaces to see if any can interfere (should not if you followed first check, but still good test)

Another issue that happened to a customer: he has a very old ShowNET DAC. "Very old interfaces may not have all licenses internally, so they don't open the connection. Most important info is the licensing screen of the admin tool. If it only shows the ShowEditor license and is missing the six dummy licenses, then the internal licensing of the card must be updated. Then you need to send the hardware ID of that ShowNET to LaserWorld and they will send you a code to add dummy licences"

[mw/mf0]

Hi Patrick,
i'm using ShowNet with MadLaser a fair bit and yes, it is fiddly to get it started, but eventually it always works.
Two "issues" overlap usually: computer not establishing DCHP to laser +and+ MadLaser shows an out-dated connection.

My usual steps:

** First check if ShowNet interface & laser are working:
1) Dip-switch pin8 is on: demo pattern should be lasered!
2) If nothing is lasered, check Key, Interlock and the Cap in front of the laser
(3) Of course power needs to be on, all cables connected.)

** Network link computer to ShowNet interface
1) ShowNet set to DHCP (Dip-switch pin6 is on, all other pins off)
2) Network adapter on computer set to DHCP
3) Check in ShowNET-admin-tool if it finds the laser! (very handy to have it installed)
4) If laser is not found - which happens often - reboot the computer. This is the only reliable solution that works for me.
Now check again in ShowNET-admin-tool. If it sees the laser, the network link is working.

** MadLaser connecting to ShowNet interface
1) On start-up MadLaser shows the last connection it had, like in your screenshot - this is usually not working!!
2) You need to select "None" first, then click on the dropbox again, now you should have your new connection available.
3) Select it and use MadLaser's testpattern to see that output works.
(4) Of course the little "Turn On/Off Laser" (formerly called "Arm Laser") icon needs to be clicked and Green.)