configure Pixie Driver Enttec
  • mobyblack
    member
    Posts: 10
    Joined: Sat Apr 23, 2016 6:14 pm

    configure Pixie Driver Enttec

    by mobyblack » Sun Feb 11, 2018 2:14 pm

    Hi everyone,

    I just buy a pixie driver from enttec for control led strip WS2812b
    I configure the pixie on the enttec software, and choose the category of led and save. It's work fine on the enttec soft.
    But when I start MM It's change each time the type of led on the controler to WS2812, so I have problem of adress and color.

    Do you see a solution ?
    Thanks
  • mobyblack
    member
    Posts: 10
    Joined: Sat Apr 23, 2016 6:14 pm

    Re: configure Pixie Driver Enttec

    by mobyblack » Mon Feb 12, 2018 5:41 pm

    I pass true the problem with my enttec dmx MK2 but I only can drive 1 univers and I need 2...
    Do you see a solution

    Thanks
  • mad-matt
    garageCube team
    Posts: 412
    Joined: Mon Sep 09, 2013 5:50 pm

    Re: configure Pixie Driver Enttec

    by mad-matt » Thu Feb 15, 2018 6:13 pm

    No, MadMapper will only use one of the outputs. We'll refactor that part at some point to be more flexible, but when using many universes, using ArtNet is better anyway better there are synchronisation mechanisms.

    One solution at the moment: on Mac you can use MadRouter to route two artnet universes to each output of your Enttec Mk2 (and even more USB-DMX devices if you want...)
  • mobyblack
    member
    Posts: 10
    Joined: Sat Apr 23, 2016 6:14 pm

    Re: configure Pixie Driver Enttec

    by mobyblack » Fri Feb 16, 2018 1:11 am

    Thanks for your solution I will try Tomorrow
    By the way I'm in communication with the support from Enttec for see if it's a hardware problem

Who is online

Users browsing this forum: No registered users and 1 guest