garageCube

[SanderK]

Hi Guys

I have rendered all the clips in 320x240 and each time I choose a clip it will be shown just half because the output resolution is 640x480. Is it possible to switch the normalize button already on when I create a new layer? I'm afraid that I will forget to switch it on, on a gig and for my purpose it should be always switched on.

thx

[VJnutcracker]

Same here, i render at 512x384 (half of 1024x768) and get the same problem.
An option in preferences would be handy.

[Lupin]

an answer to your this issue is to use the master scale property bar and zoom until you reach the correct size.then each time you'll load a media at half resolution it will be displayes at the correct size.

[boris]

You can also use the "default layer" module (on the online library)