Sound analysis stops calculating low/mid/high bands
  • geoffmatters
    activ8 member
    Posts: 71
    Joined: Fri Sep 29, 2017 3:29 am

    Sound analysis stops calculating low/mid/high bands

    by geoffmatters » Sun Jul 21, 2019 11:07 pm

    Sound analysis works for a while. Then at some point a few minutes later, low mid and high bands stop being generated. Sound response in "LEVEL" mode works, but "MID FQ" doesn't The Sound Analysis window showed bouncing green OSX standard GUI meters for the three bands. Once the analysis stops working, those meters disappear completely from the GUI... it stops rendering even the empty grey meter.

    Observed in 3.1.3 and 3.1.4

    At the moment I am setting up "Loopback" to internally route audio from other apps into M8. I have the "Loopback Audio" device set at system input. I was doing sound analysis on built-in microphone a month ago and didn't observe this problem, so there may be something special about this which is triggering the M8 bug?
  • magnetic mirror
    junior Member
    Posts: 1
    Joined: Fri Aug 16, 2019 1:26 am

    Re: Sound analysis stops calculating low/mid/high bands

    by magnetic mirror » Fri Aug 16, 2019 1:31 am

    Hi

    I've got this problem too, since upgrading to Mojave 10.14.5 and V3

    Modul8 sound analysis won't work anymore!

    Any joy?!

    Thanks

    Joe

    www.magneticmirror.net

Who is online

Users browsing this forum: No registered users and 1 guest