MM 2.2 dmx output mad- 10.10.5 - enttec dmx usb pro mk2
  • Alexander
    junior Member
    Posts: 1
    Joined: Fri Nov 13, 2015 5:19 pm

    MM 2.2 dmx output mad- 10.10.5 - enttec dmx usb pro mk2

    by Alexander » Fri Nov 13, 2015 5:23 pm

    Hi Peoples,

    this is my last try to figure out what is going on with my Software/Hardware setup.
    Simply, my Enttec is not coming back to MadMapper DMX output. It was working fine two weeks ago.
    What i did so far:
    - checking/ installing driver FTDI, enttec shows up in the system profiler
    - terminal check with page 15 http://www.ftdichip.com/Support/Documen ... AC_OSX.pdf was good
    - reinstall everything again, madmapper also
    - Arena is able to run the enttec device, Millumin also, MM2.2 not
    - installed helper 2xx, nothing changed
    any ideas?
    thanks, alexander


    results:
    151114_:


    terminal request
    kextstat | grep com.FTDI
    153 0 0xffffff7f8313c000 0x7000 0x7000 com.FTDI.driver.FTDIUSBSerialDriver (2.3) <134 39 5 4 3 1>
  • mad-matt
    garageCube team
    Posts: 1636
    Joined: Mon Sep 09, 2013 5:50 pm

    Re: MM 2.2 dmx output mad- 10.10.5 - enttec dmx usb pro mk2

    by mad-matt » Fri Nov 20, 2015 11:45 am

    Hi Alexander,

    MadMapper uses the VCP driver installed natively in Mac OSX. I suppose Millumin is using D2XX. Both driver cannot run at the same time.
    There is an application to switch driver: http://macdownload.informer.com/ftdidrivercontrol/

    I suppose it will solve.
    Cheers,
    Matthieu - MM team

    PS: for fast support use our support system ;-)

Who is online

Users browsing this forum: Baidu [Spider] and 32 guests

cron