spacial scan with more than one beamer ?
Posted: Thu Mar 28, 2013 8:48 pm
Hi ,
i am doing a test with more than one beamer.
1 th2go = 3 Outputs .
It´s a 180° projection in a room with 3 walls.
is this a setup where i can use the spacial scan?
Or is the spacial scan only for one projector and one wall ?
Or do i need to do 3 spacial scans all from the position of the beamer
and stich the picture later together.
i´m going to do the test the next days and i´m trying to figure out which the
best workflow could be.
any help would be great .
thanxs
pele
i am doing a test with more than one beamer.
1 th2go = 3 Outputs .
It´s a 180° projection in a room with 3 walls.
is this a setup where i can use the spacial scan?
Or is the spacial scan only for one projector and one wall ?
Or do i need to do 3 spacial scans all from the position of the beamer
and stich the picture later together.
i´m going to do the test the next days and i´m trying to figure out which the
best workflow could be.
any help would be great .
thanxs
pele
- center
- zentral_mit_rechts.jpg (158.91 KiB) Viewed 4483 times
- left
- zentral_mit_links.jpg (161.33 KiB) Viewed 4482 times