garageCube

[enticetz]

I'm new to MadMapper and trying to figure out how to map the LEDs in my ARRI Orbiter, Aperture nova600. I've done a lot of research but I really cant figure out what I need to do to set this up as a fixture and get MadMapper to communicate with the light.

I definitely have a good connection to the light because I'm already controlling it from my mac via the light's webpage interface.

[MADben]

In order for Madmapper to communicate with your light, you do need a controller (artnet or dmx for instance), and set it up first.
Did you check this playlist? https://www.youtube.com/watch?v=1a7Rqk7 ... a-K0CkRLtC
I dont know if it will be helpful at this point, but here's an awesome webinar for ARRI/Madmapper : https://www.youtube.com/watch?v=mhCJO_k2rzQ

[enticetz]

My Macbook, Exalux and SkyPanel are well connected

it's working well too

What I'm curious about is the ARRI Orbiter Mode1 , Aperture Nova 600 Mode1, 11 fixture editor.