Hi,
I would like to play a scene when a button is pressed. The button is connected to my arduino. I have two arduinos currently, the Nano BLE 33 and an Uno. The Uno is compatible with Firmata, however I can't figure out how to get MadMapper to recognize when the button is being pressed. The Nano is not compatible with Firmata, however I was able to write some code to get it to act as a keyboard and send ASCII codes to MadMapper to change scenes. This does change the scenes on a button press, but after 5-10 minutes, the buttons stop working (they are LED light-up buttons and will not even light up when pressed after some amount of time). This is probably an issue with delays in my code, but regardless, I am at a loss. Ideally, I'd like to somehow just make MadMapper recognize when a button is being pressed with the Nano without having to use the keyboard solution. I'm fairly new to MadMapper, so I feel like there's something I'm probably missing. Any help and/or guidance is greatly appreciated!
Thank you,
Alison Huffman