garageCube

Hi all,
I've an old Netgear wireless adsl modem router DG834G. I'd like to use it instead of a 30m ethernet cable.
The Netgear is plugged to a Chauvet DMX-AN2 (2 univers), Madmapper see the router with ip address 192.168.0.2

The little led's on the Netgear port 01 and on the DMX-AN2 are blinking :


But at the rear of the DMX-AN2 the port A led should blinks to inform that datas are going out to the Garagecube's LED bars (SFX01 RGB 0.5cm), nothing occurs...

Is there something to setup up or this netgear router is to old ?
Thanks in advance for support

you should sent the artnet data to your DMX converter adress, not the router's adress.

how can I do that ?
when I'm logged to the wifi router, the only ip address madmapper sees is the router one not the dmx-an2

MadMapper shows the Ip address of your computer network adapter. If you activate unicast you're supposed to see in the routing table your ArtNet->dmx node (Chauvet DMX-AN2).
Which universes is your Chauvet node configured to listen to ? Maybe you're sending from MM on universe 0 and the chauvet node is configured to receive universes 3 & 4 for instance. Check that in your node settings.

Hi,
here is the madmapper preference, there is nothing after clicking the "Poll" button :

Okay. Can you know your node IP address ? Maybe it's not in DHCP but in static IP. Generally IP devices are cofigured in
ip 2.xxx.xxx.xxx / network mask 255.0.0.0
or
ip 10.xxx.xxx.xxx / network mask 255.0.0.0
So this wouldn't work. You should first know your device IP / access its configuration. Check your device documentation.

hi, the router ip address is : 192.168.0.1
below the router stat :

I'm not talking about the router, but about the ArtNet node IP address

my node ip is : 2.0.0.1

finaly I found how to do it !

the Netgear router has a static ip address : 2.0.0.3 (mask = 255.255.255.0)
the macbook pro is connected to the router by wifi and has a static ip address : 2.0.0.2 (mask = 255.255.255.0)


In madmapper on dmx output, the wireless interface must be selected : Wireless (en0) - 2.0.0.2

and now the artnet node ports A and B are blinking


I hope this might be helpfull for other