garageCube

Am currently re-designing an application for MADMAPPER CONTROL, using OSC, now that in the newest BETA version there is the option to TAB through CORNER PINS - this allows for very fast editing "up close and personal" to the screen surfaces.

However, I as having a problem when it comes to ZOOMING in on a selected surface.

The shortcut CMD+PLUS only zooms the view in as far as the actual composition canvas !

However, if you use the actual PLUS and MINUS buttons above the output preview window, you can zoom in as much as needed.

This ability to ZOOM right in is very useful fro precise pixel adjustment.

Anyone got any ideas, or is it just in the new BETA version? (unfortunately my current laptop only has the BETA version on so i can't check older version history)

Many thanks

PHIL

in version 1.4:
z zoom to selected surface
CMD + zoom in (no limit)
CMD - zoom out
CMD = zoom stage extends

Thanks Franz!!

Was a case of OSCULATOR seeing CMD+PLUS without the SHIFT so it was just zooming to fit !

All resolved

Many thanks, and thanks for a great update 1.3 and 1.4 really good big changes

Thanks again

PHIL