garageCube

hi -

is there a way of control 2 dmx nodes at the same time in mad mapper?

i think maybe with unicast but i still can do it.

i want to use a LDMX4 ( for smart stripes ) and at the same time a Entecc ethernet open dmx -

thx !

normally there should be no problem i already used madmapper with 3 different artnet controller at the same time. Do your nodes show up in the screen? did you try putting the ip manually? do they both have the same ip?

Goto MM/yourspace and Download MadRouter application. That might work for you.

Use ArtNet and and Enttec ODE or other ArtNet->DMX node. So MadMapper can send ArtNet to everyone. Then you can have one node converting ArtNet universe 0 to DMX, another to convert ArtNet universe 1 to DMX, a LED controller getting ArtNet universes 10-20 to drive LEDs etc.