Hello Forum- I hope you are doing well!
I need to send separate artnet and sacn signals to different devices during one project. I read up on the dmx router module which sounds perfect. When activated, the output device window does not detect my dmx devices even though one the individual signals are being sent and received. I was using a dmx splitter which I removed from the signal path and went direct to the driver but still no recognition. I tried the Check for Devices function but no. The universe setting is correct. Are driver or decoders not recognized by DMX Router? Here are the devices I need to send control signal to:
https://www.obsidiancontrol.com/products/rdm-10
https://chauvetprofessional.com/product ... lex-drive/
Thank you,
Fredomatic