garageCube

[alexander034]

I try to made the LED tutorial files that i download from archive.
I select my WS2801 led in the Arduino sketch.
Upload the sketch, run correctly and the MadMapper is communicate with the arduino board, i see the dmx lines..etcetc but the LEDs not working.
Just test the LED lines are work correctly.
Where is the problem?

[Benoit]

which LED tutorial file did you use? it may be outdated

[alexander034]

MadMapper_LED_Tutorialfiles.zip i found in the archive.
I try to found the solution. When i changed the baud rate, the led is working but very glitchy.
The first problem is the Arduino Uno...too slow i read a post in the forum.
I ordered a TEENSY and i try again