garageCube

I try to made the LED tutorial files that i download from archive.
I select my WS2801 led in the Arduino sketch.
Upload the sketch, run correctly and the MadMapper is communicate with the arduino board, i see the dmx lines..etcetc but the LEDs not working.
Just test the LED lines are work correctly.
Where is the problem?

which LED tutorial file did you use? it may be outdated

MadMapper_LED_Tutorialfiles.zip i found in the archive.
I try to found the solution. When i changed the baud rate, the led is working but very glitchy.
The first problem is the Arduino Uno...too slow i read a post in the forum.
I ordered a TEENSY and i try again