garageCube

Hey all,

to play arround a bit before a Pixlite arrives, i am struggeling with the Mad Mapper*s two line example and the corresponding settings in the DMX Output. The only annoying thing here is , that i got it working, played arround and cant come back to the original working point


1) Test Leds - two strips of 300 LEDS (WS2812B) each

2) Arduino

#define NUM_LEDS_LINE0 300
#define DATA_PIN_LINE0 14
//#define CLOCK_PIN_LINE0 6

#define NUM_LEDS_LINE1 300
#define DATA_PIN_LINE1 2
//#define CLOCK_PIN_LINE1 6

...


3) Madmapper

I tried it with


1) Universe 0 - Start Channel 1 - Channel Count 512 - Outline 1 - Out Channel - 0
1) Universe 1 - Start Channel 1 - Channel Count 512 - Outline 1 - Out Channel - 512
2) Universe 2 - Start Channel 1 - Channel Count 512 - Outline 0 - Out Channel - 0
1) Universe 3 - Start Channel 1 - Channel Count 512 - Outline 1 - Out Channel - 512

but it doesn't work, and i cant remember what i changed, that it stopped working



In addition I also dont get , why i need for the one-line example with a 300 LED WS2812B Strip two universes with

1) Universe 0 - Start Channel 1 - Channel Count 512 - Outline 1 - Out Channel - 0
1) Universe 1 - Start Channel 1 - Channel Count 512 - Outline 1 - Out Channel - 512


to get the full strip working




I guess i have to dig deeper into this universe stuff ? I also got ~ 6 strips working with a single line, but want to play with the different outputs / two lines example

Cheers