garageCube

I am aware that the micromodul8 was not created for MM in mind but I have been using it with MM almost exclusively with not much issues. That said over two years ago I realised that MM does not respond well to the step knobs of the micromodul8. Binding the step knob to a slider control in MM and turning the step knob results in the slider locking to the far left or far right of the slider control.

Probably not a high priority.

I do think there could be more compatibility for MM with the micromodu8. For example with having presets available for different que banks?

MadMapper does handle it like in the past. Just since those buttons are "incremental", you have to setup the CC type in MadMapper Control. I think the right type is "2's Comp", but you'll find easily by trying all types.