Dmx input from hog4pc
  • crumpetsauce
    junior Member
    Posts: 1
    Joined: Thu Nov 19, 2026 5:31 am

    Dmx input from hog4pc

    by crumpetsauce » Thu Nov 19, 2026 5:45 am

    Hello all,

    I am trying to send a dmx signal from my hog4pc to trigger the conductor. I am having a hard time trying to get the dmx input into madmapper. I have two computers connected via switch. I am able to ping each computer. I have Sacn and Artnet output toggled on the hog with a widget to unlock the universe output. Under madmapper project settings I have selected the ethernet interface, tried universe 1 and 0 with artnet.

    I get no response with the dmx monitor, Not sure if this is monitoring dmx input or output. Then I made a few blank scenes and add dmx control set to channel 1 and 2 and no response, if I hit learn and toggle some channels on and off I get no response.

    I'm wondering If I am doing something wrong here, also what to troubleshoot next. I am using 6.1.7 Demo version.

    Any help would be greatly appreciated,

    Thanks

Who is online

Users browsing this forum: No registered users and 32 guests

cron