Page 1 of 1

Dmx input from hog4pc

Posted: Thu Nov 19, 2026 5:45 am
by crumpetsauce
Hello all,

I am trying to send a dmx signal from my hog4pc to trigger the conductor. I am having a hard time trying to get the dmx input into madmapper. I have two computers connected via switch. I am able to ping each computer. I have Sacn and Artnet output toggled on the hog with a widget to unlock the universe output. Under madmapper project settings I have selected the ethernet interface, tried universe 1 and 0 with artnet.

I get no response with the dmx monitor, Not sure if this is monitoring dmx input or output. Then I made a few blank scenes and add dmx control set to channel 1 and 2 and no response, if I hit learn and toggle some channels on and off I get no response.

I'm wondering If I am doing something wrong here, also what to troubleshoot next. I am using 6.1.7 Demo version.

Any help would be greatly appreciated,

Thanks