Madmapper with multiple triplehead2go units
Posted: Fri Jan 06, 2012 6:37 pm
HI,
is there way to configure MM to span across 2 matrox triplehead2go units?
My Macpro is configured with 2 units each running 2 monitors, so I have 2 desktops 3840 x 1080 pixels.
At the moment MM will only output to 1 of the desktops i.e. 3840 x 1080 and not 7680 x 1080.
I can do this direct from Modul8 but actually need to rotate each monitor into portrait so I would actually have an image 4320 x 1920, this is why I need MM to rotate each section of the video.
thanks in advance
Russ
is there way to configure MM to span across 2 matrox triplehead2go units?
My Macpro is configured with 2 units each running 2 monitors, so I have 2 desktops 3840 x 1080 pixels.
At the moment MM will only output to 1 of the desktops i.e. 3840 x 1080 and not 7680 x 1080.
I can do this direct from Modul8 but actually need to rotate each monitor into portrait so I would actually have an image 4320 x 1920, this is why I need MM to rotate each section of the video.
thanks in advance
Russ