garageCube

when I open saved project - mapped output doesn't match the object. I haven't mooved anything, neither changed anithing in setup. so everytime i open the project i have to remap it on the structure. and there is minor issue with cursor all the time: it appears as a cross (as in mask mode) not the arrow so i have to click on some tab of main menu to make it arrow.

Maybe under menu output "stretch output" is by accident enabled or disabled ?

Cheers, Barney

Nope. stretching is switched off.

I was the same problem next weekend!!
The past session I must be remap my structures 3 times in 5 hours.
I had 8 presets with 10 layers and I was changed the map of same layer in the 8 presets all the nigth..
I didn't know why, but in 3 times when I changed my preset, the layer had change in all presets, it towards but small...
thanks!

can you please send a step by step instructions on how to reproduce the problem to the support.
I haven't been able to reproduce ...

EDIT: i just tried again, and couldn't reproduce your problem.
One good practice, is to lock the surfaces once you know your setup is done. This way they won't move for sure.

Hi Franz,
I lock the surfaces but, if it are locked I can't play with the output off..
My problem was that one layer was changed the position and size two or three times in all presets...
I'm think that is possible I modified any parameter with the midi map...
Next weekend I'm other video set, I will say you if I will have any problem..
Thanks!

I'm having the same problem, constantly having to remap.

Almost every time I open a saved project, a few of the quads have been changed, seemingly at random and without explanation

big headaches...

And I have the exact same problem...
Sometimes when I open the project and switch the presets, quads change the size and location. MadMapper 1.2.1

same problem !!!

(un)fortunately, the same problem happened to me this week end.
It seemed related to the preset system.
We'll investigate on this and work on a fix.

Same here, and last times I dont had presets...

Any news for a fix??? Thanks


Madmapper 1.2.1
MBP-OSX 10.6.8-i7_2.66GHz-4GB_1066MHz-7,200rpm- Nvidia GT330M_512MB

Hi !

Yes we found and fixed the problem.
An update is planned before the end of August.

Thanks,
Boris.

vj granda wrote:Same here, and last times I dont had presets...

Any news for a fix??? Thanks


Madmapper 1.2.1
MBP-OSX 10.6.8-i7_2.66GHz-4GB_1066MHz-7,200rpm- Nvidia GT330M_512MB

Thanks a lot Boris.