garageCube

for some reason suddenly on both my mackbook pro's when i fullscreen mad mapper it refuses to go to the projector screens but instead full screen the macbook's monitor. this is trying to use a tripplehead as a dualhead with resolution at 2048 x 768, which is whn the problem started.

did you configure the output projector correctly via the output tab ?
Sometimes if you hot-plug/unplug a projector, MM 1.5.1 *might* loose its config.
(should be fixed in 1.5.2)
Does it also happen after a MM relaunch ?

Hello friends,

NEED HELP! I have the same problem, I just got a Macbook Pro retina and downloaded MM, but something weird happened after the second test. First test it worked fine, I got to map my room for the test and all worked OK; In the second test I used two projectors to test MM and when I changed the input to the other projector it happened, now I only see fullscreen on my laptop! then I tried to fix this by changing the resolution on both computer and MM but no luck, I restarted MM and my Mac but not luck! could somebody please help me to fix this problem. Thanks.

Will

still having this issue, any thoughts?

this is with madmapper 1.5.2
when i load it up normally the back screen(s) go black automatically, this is not happening.

I don't really care about the extra projector options unless that's screwing something up? i always made my shows works fine before that

this is with madmapper 1.5.2
when i load it up normally the back screen(s) go black automatically, this is not happening.

I don't really care about the extra projector options unless that's screwing something up? i always made my shows works fine before that

maybe your output is set to the main displpay (laptop)
go to the output/projector tab, select your output and set it to your prefferred projector (normally appearing in the list, if a display is connected)