Fullscreen Mode command through OSC ?
  • La Fabulerie
    junior Member
    Posts: 1
    Joined: Wed Nov 25, 2020 8:14 pm

    Fullscreen Mode command through OSC ?

    by La Fabulerie » Fri Nov 27, 2020 10:39 am

    Hi,
    I'm using Madamapper for a Museum interactive installation, and I'm sending data to it through OSC (Max MSP). I wanted to automatize everything so I was wandering if there's a way to send FullScreen Mode command on startup.

    Thank you !
    Regards

    Théo Radakovitch
    La Fabulerie - Marseille

    PS : Not sure this topic has to stand on tips and tricks page, I'm new here.
  • mad-matt
    garageCube team
    Posts: 1475
    Joined: Mon Sep 09, 2013 5:50 pm

    Re: Fullscreen Mode command through OSC ?

    by mad-matt » Thu Dec 03, 2020 1:29 pm

    In MadMapper4, if you go in the Control List, press the + button, you'll find the control to enable / disable a projector so you can do it: "/outputs/Projector-1/enabled"

Who is online

Users browsing this forum: No registered users and 8 guests