E1.31 output
Posted: Mon Dec 03, 2012 1:32 pm
by bLackburst
It would make sense for madlight to output E1.31 protocol too, seeing as the majority of pixel strip controllers use it.
Re: E1.31 output
Posted: Mon Dec 03, 2012 2:32 pm
by franz
mmm.. can you link a few controllers that use E1.31 ?
Re: E1.31 output
Posted: Tue Dec 04, 2012 8:52 am
by bLackburst
http://www.sandevices.com/E681info.htmlhttp://www.j1sys.com/ecg-p12r/http://www.j1sys.com/ecg-pixad8/http://www.stellascapes.com/index.php?o ... &Itemid=62A couple of these support ArtnetII "for legacy". I'm assuming by the 131,072 channel max in madlight that would mean 255 universes making it artnet 1 or 2.
Can you recommend pixel controllers that support the fArtnet fom madlight without adapter boxes etc?
Re: E1.31 output
Posted: Mon Sep 01, 2014 3:45 am
by ghostofelvis100
Hey folks,
Did this get resolved at all?
What’s the chances I can get madMapper to run one of these:
http://www.ebay.co.uk/itm/DMX-512-contr ... 3386b21215(sorry this is only an ebay link and will become dead at some future point...)
Uses Artnet III, or E-131 protocol.
Could be make the difference in keeping my installation within a reasonable budget!
Cheers
Andy T.
Re: E1.31 output
Posted: Fri Nov 14, 2014 6:43 pm
by broken
ghostofelvis100 wrote:Hey folks,
Did this get resolved at all?
What’s the chances I can get madMapper to run one of these:
http://www.ebay.co.uk/itm/DMX-512-contr ... 3386b21215(sorry this is only an ebay link and will become dead at some future point...)
Uses Artnet III, or E-131 protocol.
Could be make the difference in keeping my installation within a reasonable budget!
Cheers
Andy T.
Not sure about the E1.31 output, but the ARTNET6UN works quite well with madmapper using artnet unicast