garageCube

[bratch]

Here is my question :
Would it be possible to assign one or several layers to an output of the videocard (clip in the multi output setup). By ex,
Layer 1 and 2 go to clip one
Layer 3 go to clip 2
Layer 4,5 and 6 go to clip 3
That would be juste great.

[sigmasix]

yo can move your layer to the correct position ten if you change the media of the layer, it will change at the same place

[bratch]

yes but if you have several beamers, on several screens, i'd really need this. It's better for the composition cause actually, i could do a similar thing by positionning my clips (output if you prefer) side by side, and putting the layers i need on each clip. But i'd rather have all my clips with the same position, but with assigned layers. Don't know if i'm clear enough...?

[VJnutcracker]

If i read what you're saying correctly you want layer 1+2 to output to videocard 1, layers 3+4 to videocard 2 and layers 5+6 to videocard 3

I dont think thats possible, its all about layer positioning when using multi output cards rather than assigning layers to outputs

[bratch]

yes, i know it's not possible actually, but i hope this could be on next version. It's a wish for M8 V 3 !
It would be great to assign any layer to any card.

[Lupin]

yes, i know it's not possible actually, but i hope this could be on next version. It's a wish for M8 V 3 !
It would be great to assign any layer to any card.

well you can use the default layer module, or wirte a module to position each layer to a specific place then use the advanced output setup to match outputs to each region