garageCube

hi i dont know why this happens but its starting to freaking me out, and i cant find how to fix it , i have the most actualized version and deinstalling and reinstalling doesnt have done anything, the scale parammeter its alwais at the middle, its like if i have a layer with the scale at 1/4 and i duplicate it it appears with the scale at the middle , or if i have different layer with different scale values and i save the proyect when i reopen it the values of all the layers appear at the middle of the bar. i have also turn off all the modules i have on it installed but the problem doesnt comes from there neither any one with an idea of what could i do?

Hello bal,



Are you using Modul8 2.5.8 or Modul8 2.6 RC1?

As shown here the scale slider is always by default in the center.




From what I understand in your writing is that when you:

1 - Change the scale size.
2 - Save a project file.
3 - Quite Modul8.
4 - Open the project file you just saved.

The result is that the setting of the scale of the layer is centered and not what you set it to?

I have just run a test using Modul8 2.5.8.

1 - Created 5 layers.
2 - Assigned 1 media to each layer (I only used 1 media in the project).
3 - Scaled each layer differently.
4 - Saved the project.
5 - Quit Modul8.
6 - Launched Modul8.
7 - Opened the project file.

The result was that all of the scale values remained as I had created them. So I am not able to reproduce the problem.

Can you provide me with an outline as to how I can try to reproduce the problem?[/img]