Hello,
I am experiencing very strange behavior with my miniMad. I am using the minimad recorder to export scenes using artnet unicast to a pixlite MKII controller (MM Version 3.7.4). After I load the SD card and power up the miniMad, after about a 1 minute boot cycle, the lights come on and function as expected, running through all the scenes and looping back from the beginning. However, after I power down and power up again, the lights come on after another minute or so but then go out after two scenes. The third time I power up, the lights never come on. In subsequent attempts, the lights sometimes come on, sometimes do not, but they always shut off after one or two scenes.
The same behavior happens (works first time, fails subsequent times) every time I reload the SD card.
Attached are my madlight recorder settings.
Power cycle 1 (lights turn on after 1 minute and scenes run correctly, green light out of ethernet port blinking consistently quickly): https://youtu.be/YCWoGc6T1I0
Power cycle 2 (lights turn on after seconds, lights turn off after first scene, green light out of ethernet port blinking consistently while lights are on, when they shut off, light out of ethernet port blinks green still but more slowly): https://youtu.be/61ocexP8XHs
Power cycle 3 (lights never turn on, green light out of ethernet port solid)
Power cycle 4-10... lights come on most of the time but shut off after 1 to 3 scenes.
Can you please help me figure out what is happening?
Thanks,
Aidan