garageCube

Hi,

I made a permanent projection installation recently with MiniMad but the projector was slightly moved. Due to that the projection is mismatched with the surface and it needs to be adjusted. It's very difficult to access the projector therefore I am hoping that there is a way to shift the entire projection from MiniMad. Can you use the onboard buttons to do that? The mapped surface has many quads and masks so I would like to simply shift the entire image at once. Please advise. Thank you!

you can use the buttons indeed, press the red one to activate mapping mode (more details in the minimad guide)
otherwise, you'd need a computer and MadMapper in order to shift the entire projection

Thank you

A precision: using MiniMad's buttons (or USB computer-keyboard), you can either adjust each individual surfaces, or move all surfaces at once by pressing YELLOW (previous control point) right after entering mapping control mode by pressing RED.