Etherdream looses connection
  • MikkelM
    junior Member
    Posts: 2
    Joined: Fri Apr 08, 2022 10:34 am

    Etherdream looses connection

    by MikkelM » Sun Sep 11, 2022 9:27 pm

    Hi There.
    We are running Madlaser with 3 Etherdreams on windows 11. From time to time an Etherdream stops working, but continue to say connected in Madmapper. We then have to set the connection to None and then back to the right Etherdream again to get it to work.

    Is it a bug in Madlaser or Etherdream firmware?

    /Mikkel
  • franz
    madMapper master
    Posts: 1033
    Joined: Fri Feb 18, 2005 7:05 pm
    Location: Paris, France
    Contact:

    Re: Etherdream looses connection

    by franz » Mon Sep 12, 2022 9:57 am

    known bug in etherdream firmware.
    We "could" fix it by rewriting the driver entirely.
  • Simon_Holden
    member
    Posts: 21
    Joined: Tue Oct 06, 2020 1:43 am

    Re: Etherdream looses connection

    by Simon_Holden » Sat Feb 10, 2024 6:48 am

    I'm getting the same sort of problem, it doesn't seem to happen as much when I'm using the standard materials, but if I try to use a material and or something with lots of points it drops out. Sometimes I can bring it back by changing the destiation to none, then back to the etherdream, but this doesn't always work. The Etherdream sometimes says Status:Disconnected, in which case I need to drop the power to the etherdream to get it back... Any thoughts as to why this might be happening?

    If I put the PPS up to 45 kpps it happens almost immediately, at 30kpps its less frequent.

Who is online

Users browsing this forum: No registered users and 3 guests